Bluetooth Controller:

• Requires 12V power source
• Requires 1 3/8" diameter hole
• Dimensions (W x D)2" x 2"
• Wireless Bluetooth Streaming
• IPX6 Waterproof

Speaker:

• Power Handling: 100 watts RMS, 300 watts peak power
• Sensitivity: 92dB at 2.83 volts
• Frequency Response: 40 - 25kHz
• Voice Coil Diameter: 1 in. (25.5mm)
• Impedance: 3 ohm impedance
• Plus One Woofer Cones
• One Piece Polymer Basket
• DO NOT USE DRILLS ON THE SCREW SPEAKER TERMINALS EVER.
• Loosen and Tighten BY HAND ONLY.  Using a Drill snaps the solder connection on the back of the terminal and the X-over (coax) Circuit board.

Amplifier:

• 4 Channel Marine Amplifier
• Class D Technology
• Max Power - 1000W Peak
• Power Output, 2Ω - 100W RMS x 4
• Power Output, 4Ω - 70W RMS x 4
• Power Output, 4Ω Bridged - 200W RMS x 2
• Signal-to-Noise Ratio - ≥85dB
• High and low level inputs
• Variable crossovers and bass boost

Amplifier Wiring Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place