Controller:

• Requires 12V power source
• Requires 1 3/8" diameter hole
• Dimensions (W x D)2" x 2"
• Wireless Bluetooth Streaming
• Rotary Encoder
• IPX6 Waterproof
• Flush Mount

Speaker:

• Power Handling 200W RMS/500W peak
• Sensitivity 92dB at 2.83 volts
• Frequency Response 30 - 22kHz
• Voice Coil Diameter 1 in. 
• Impedance 3 ohm impedance

In The Box:

• 2 x 8" (200mm) woofers, pr.
• 2 x Flush mount adapter W/Integrated grille, pr.
• 12 x Screw
• 12 x Speed clip
• 1 x Spanner
• 2 x Closed cell foam gasket
• 1 x Twin pin tool
• DO NOT USE DRILLS ON THE SCREW SPEAKER TERMINALS EVER.
• Loosen and Tighten BY HAND ONLY. Using a Drill snaps the solder connection on the back of the terminal and the X-over (coax) Circuit board.

Amplifier:

• 4 Channel Marine Amplifier
• Class D
• Max Power - 1000W Peak
• Power Output, 2Ω - 100W RMS x 4
• Power Output, 4Ω - 70W RMS x 4
• Power Output, 4Ω Bridged - 200W RMS x 2

Amp Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires 
• Upgrading Harmon Kardon System Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along with a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier in place