PACKAGE BUNDLE INCLUDES: JBL JAM3000 Bluetooth AM/FM Radio IP66 Multi-Element Digital Media Marine Audio Receiver, 4x JBL Marine Stage 6 6.5" 180 Watts Peak Power 2-Way Multi-Element Boat White Speakers, JBL Stage Marine 10" OEM REPLACMENT 600 Watts Peak Power Audio White Subwoofer (Pair, Bulk Packaging), JBL Marine A5055 5-Channel Boat Amplifier W/ Wiring Kit

Receiver:

• 2.8” Monochrome LCD Display
• 15 Watts x 4 Channel @ 4ohm
• Supports multiple audio sources
• Audio output - RCA & Speaker level
• RMS Power Output 15Wx4
• 3Ch/2V Pre-out
• Mounting options: Front & Rear

In The Box:

• 1x radio
• 1x accessory harness
• 1x mounting bracket
• 1x foam gasket for sealing at rear mounting surface
• 2x foam strip gasket for sealing at front mounting surface
• 4x mounting screws
• 2x mounting bolts for top mount
• 4x flanged nuts
• 2x lock washers
• 1x owner’s manual
• 1x safety sheet

Speaker:

• 6-1/2" (160mm) Marine Two-way Speaker with 1/2" (13mm) tweeter
• Power Handling: 60W rms, 180W peak
• Sensitivity (@ 2.83V): 90dB
• Frequency Response: 60Hz – 20kHz
• Nominal Impedance: 4 ohms

Subwoofer:

• Marine Design
• Power Handling: 200Wrms, 600W peak
• Sensitivity (@ 2.83V): 88dB
• Frequency Response: 30Hz – 250Hz
• Nominal Impedance: 4 ohms

What's in the box?:

• 1 x Subwoofer with attached grille
• 1 x Stainless steel mounting hardware
• 1 x Drill bit for easy installation
• 1 x Foam gasket
• 1 x Subwoofer pigtail harness
• 2 x JBL sticker
• 1 x Quick Start Guide

Amplifier:

• 5-ch Marine amplifier
• 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
• 75 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
• 100 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
• Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
• Low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel
• Bass boost on subwoofer channel (0-12dB at 45Hz)
• Phase switch on subwoofer channel (0, 180 degrees)
• Preamp and speaker-level inputs
• Fuse rating: 30A x 3
• 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier

Amp Wiring Kit: 

• 6 feet of red and black T-Spec OFC power and ground wire 
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along with a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place