Receiver:

• Single DIN Receiver
• Bluetooth Audio Mode and Hands Free Calling
• FM Radio Tuner
• Playback from USB drives and SD memory cards
• AUX input
• Recommended Speaker Impedance: 4 Ohms
• Frequency Response: 20 Hz - 20 kHz
• Rated Output Power: 4 x 50W Peak
• Signal to Noise Ratio: 70dB
• Detachable Face

6.5" Speakers:

• 6.5" 2-way Marine speakers
• Power range: 75 watts RMS / 225 Watts Peak
• Polypropylene woofer cone with UV-resistant rubber surround
• Grille-mounted 1" polypropylene semi-dome tweeter.
• Frequency Response: 50-20,000 Hz.
• Sensitivity: 92 dB

Amplifier:

• Alpha 1302A Car Amplifier
• 2 Channel
• Class AB
• Max Output: 500 Watts Peak Bridged at 4 Ohms
• Max Output: 150W x 2 at 4 Ohms
• RMS Ouput: 65W x 2 at 4 Ohms
• RMS Output: 85W x 2 at 2 Ohms
• RMS Ouput: 170W x 1 at 4 Ohm Bridged
• SN Ratio: 75 dB
• Frequency Response: 10Hz-45Khz
• Adjustable High-Pass/Low Pass Crossover Filter

Stereo Housing Cover:

• Universal Marine Stereo Housing
• Protect your Stereo from Harsh Marine Environment
• Includes a 2 Position Hinged Front Door
• Sealed with a Neoprene Gasket
• Accommodate Dual Post/ Removable & DIN Style Stereos
• Fits Din Style or Removable Stereos
• U shaped Mounting Bracket for Deck or Overhead Installation
• Stainless Steel Mounting Hardware
• Polycarbonate Bracket
• UV Resistant Plastic

Antenna:

• Weather Resistant
• 40" Braided Cable.
• Full AM/FM reception.

Amplifier Wiring Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place