Receiver:

• 2.8” Monochrome LCD Display
• 15 Watts x 4 Channel @ 4ohm
• Supports multiple audio sources
• Audio output - RCA & Speaker level
• RMS Power Output 15Wx4
• 3Ch/2V Pre-out
• Mounting options: Front & Rear

In The Box:

• 1x radio
• 1x accessory harness
• 1x mounting bracket
• 1x foam gasket for sealing at rear mounting surface
• 2x foam strip gasket for sealing at front mounting surface
• 4x mounting screws
• 2x mounting bolts for top mount
• 4x flanged nuts
• 2x lock washers
• 1x owner’s manual
• 1x safety sheet

Speaker:

• 6.5" 2-way speakers (Pair)
• Marine-Grade
• Multi-Color RGB LED Lights
• Plus One Woofer Cone
• Grille-Mounted Mylar Tweeter
• One-Piece Cast Polymer Basket
• IPX5 Rated for Water Resistance
• Power Handling: 100 watts RMS (300 peak)
• Sensitivity: 92 dB at 2.83 volts
• Frequency Response: 40-25,000 Hz
• Impedance: 3 ohms

Subwoofer:

• 10" 3-Way Subwoofer
• Power Handling: 300 watts RMS
• Power Handling: 900 watts Max
• Sensitivity: 89dB
• Frequency Response: 20-2KHz
• Impedance 2 and 4-ohms, Switch Selectable Impedance (SSI)
• 7 color RGB LED Lights - expandable with remote
• Marine Grade IPX3 and IPX5 rated
• UV resistant
• Plus One polypropylene woofer

Amplifier:

• 5 Channel Marine Amplifier
• 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
• 75 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
• 100 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
• Class AB+D amp technology
• Bass boost and low pass filter on subwoofer channel
• RBC wired remote - volume adjustment
• Variable high and low-pass filters on front and rear channels
• Preamp and speaker-level inputs
• Preamp outputs
• Fuse rating: 30A x 2
• 4-gauge power and ground leads recommended
• Wiring and hardware not included

Amp Wiring Kit: 

• 6 feet of red and black T-Spec OFC power and ground wire 
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along with a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place