Receiver:

• Single DIN Receiver
• Bluetooth Audio Mode and Hands Free Calling
• FM Radio Tuner
• Playback from USB drives and SD memory cards
• AUX input
• Recommended Speaker Impedance: 4 Ohms
• Frequency Response: 20 Hz - 20 kHz
• Rated Output Power: 4 x 50W Peak
• Signal to Noise Ratio: 70dB
• Detachable Face

6.5" Speakers:

• Power Handling: 240W Peak
• Recommended Power Range: 6 - 60 watts RMS per channel.
• Rigid polypropylene cone material.
• Polyester foam speaker surround.
• Stamped steel basket.
• EVC (Extended Voice Coil) technology, for excellent sound.
• 1/2" zero protrusion polyetherimide tweeter.
• Neodymium tweeter magnet.
• PEI (polyether imide) balanced dome tweeter.
• 4 ohms impedance.
• Frequency Response: 40 - 20,000 Hz.
• Sensitivity: 90dB.
• Grilles included.

Amplifier:

• 4-channel marine/powersports/ car amplifier
• 45 watts RMS x 4 at 4 ohms (60 watts RMS x 4 at 2 ohms)
• 120 watts x 2 bridged at 4 ohms
• Class D amp technology
• 720 Watts Peak Power
• 2 or 4 channel input
• Signal to noise ratio 97db
• Frequency Response: 20Hz to 20KHz

Speaker Mounting Adapters:

• 6-1/2" - 6-3/4" Speaker Adapter Plate
• For 1998-2013 (FL models with fairings) Harley Davidson Touring
• Gapless fit between the speaker and the kit
• High-grade ABS plastic construction
• Color: Black

Stereo Install Kit:

• Single DIN radio provision
• For Harley Davidson (FL models with fairings) Touring 1998-2013
• Gapless fit between the dash and the kit

Amplifier Wiring Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place